MODEL R SERIES
The R Series is used anywhere extra heating capacity is needed. Designed for residential and commercial applications on 6” diameter ducts. The R series heat pack improves heating system balance problems. Comes with an integral axial fan which produces approximately 160 CFM during operation and is intended for use with either a remote wireless or wired thermostat, to be wall mounted inside the heated room.
- Commercial Grade Heating Coil and Rack
- Direct Install To HVAC Boot
- Approved Zero-Clearance Installation
- Fan Mode Can Boost Air Conditioning
- Eliminates Supplemental Space Heaters
- Improved Heating Efficiency (point of use)
- Maintains Consistent Comfort Level
- Minimal Heat Loss
- Easy To Install
Cold Spots? Add A Boost To Your Heating System
If you experience hot and cold spots inside your home, it doesn’t have to be that way. R Series duct heaters directly install in-line with your HVAC boot or existing ductwork to increase the heat output in a given room.
Composition and Materials: All sheet metal housing. 0.034+.008/-.00 minimum spangle galvanized sheet steel grade G-90.
Accessory Options: Standard supply voltages from 120-1440 & Standard control voltages from 120-277 single or three phase heaters, Slip In or Flange mounted, Recessed control box, right handed offset control box, 80/20 (Ni/Cr) resistance wire, Stainless steel terminals, Derated coils, vapor barrier and gasketed cover.
Standard Features: Direct install to HVAC boot or existing ductwork, commercial grade heating coil and rack, UL approved for zero-clearance installation without additional insulation, wired or wireless thermostat, custom Hanger system, Insulated unit and triple safety protection.
Applications: Bathrooms, bedrooms, nurseries, garages/attics, sunrooms, offices, lobbies, under floor systems and workshops.
Approvals: cULus, ETL, UL International